> E TVRecEvent recorders/dvbchannel.cpp:1026 (GetSignalStrength)ĭVBChan(/dev/dvb/adapterPC800i/frontend0): Getting Frontend signal > E ProcessRequest programinfo.cpp:2358 (GetPlaybackURL) Unrelated to your shutdown issues but may need to be investigated: > Although I saw this (several times similar message), most likely > E Scheduler scheduler.cpp:2943 (ShutdownServer) SetWakeuptimeCommand > N Scheduler scheduler.cpp:2937 (ShutdownServer) Running the command to More to it but I suspect this will be a good place to start (it occurs > I only scanned the log file very very briefly so not sure if there is > Everything looks the same to me, when I compare Precise to Trusty. > the BE log, set verbose, is in the bin below Precise, I'm almost there, but it wont shut down.
> Greetings Mythizens, I'm still trying to get Trusty to behave like There were a few other errors but they occurred earlier in time so you might have fixed those by now. W TVRecEvent recorders/dvbsignalmonitor.cpp:93 (DVBSignalMonitor) DVBSigMon(/dev/dvb/adapterPC800i/frontend0): Cannot measure S/N#012#011#011#011eno: Invalid argument (22) W TVRecEvent recorders/dvbsignalmonitor.cpp:91 (DVBSignalMonitor) DVBSigMon(/dev/dvb/adapterPC800i/frontend0): Cannot measure Signal Strength#012#011#011#011eno: Invalid argument (22)Į TVRecEvent recorders/dvbchannel.cpp:1055 (GetSNR) DVBChan(/dev/dvb/adapterPC800i/frontend0): Getting Frontend signal/noise ratio failed.#012#011#011#011eno: Invalid argument (22) And: E TVRecEvent recorders/dvbchannel.cpp:1026 (GetSignalStrength) DVBChan(/dev/dvb/adapterPC800i/frontend0): Getting Frontend signal strength failed.#012#011#011#011eno: Invalid argument (22) I only scanned the log file very very briefly so not sure if there is more to it but I suspect this will be a good place to start (it occurs quite a lot particularly near the end): N Scheduler scheduler.cpp:2937 (ShutdownServer) Running the command to set the next scheduled wakeup time :-#012#011#011#011#011#011#011sudo /usr/bin/setwakeup.sh 1409083753E Scheduler scheduler.cpp:2943 (ShutdownServer) SetWakeuptimeCommand failed, shutdown aborted Although I saw this (several times similar message), most likely unrelated to your shutdown issues but may need to be investigated: E ProcessRequest programinfo.cpp:2358 (GetPlaybackURL) ProgramInfo(1621_20140825010000.mpg): GetPlaybackURL: '1621_20140825010000.mpg' should be local, but it can not be found. The BE log, set verbose, is in the bin belowĮverything looks the same to me, when I compare Precise to Trusty. Greetings Mythizens, I'm still trying to get Trusty to behave like Precise, I'm almost there, but it wont shut mythshutdown -cOK to shutdown